Metal Gates Works
A gate is use as an entry or exit into a plot. It may also be use to secure the home compound. This made of different materials and can be Fix metal Gate. They could made with timber, steel sections or metal sheets. The home owner desires a beautiful entry into the compound. the gate may have a sentry cubicle on the side to control movement into and out of the compound. The height can vary depending on the location. If its fixed on a long driveway it can be open by remote control.
The gate should fix such that the home owner can open and close effortlessly. It is important to have the posts hanging the gate very strong And Fix metal Gate. The hanging post can made of steel or concrete stanchions. This should not buckle under the weight. The hinge system should be able to open and close smoothly. On the hanging stanchion, a bell or security system can be install. Also lighting should be provide for ensuring a lit entry or exit into the home. Also a gate sensor can be add.
Once the gate is fabricate then fixing commences. The width of the gate is measure and the support post position is establish. Column pits are excavate to a depth of three feet. The stanchions are plumb and kept straight upwards. These should also be in line. The stanchion column is then put into the excavated holes. Concrete of one part cement, two parts sand and four parts ballast is mix and poured into the pit. It is then vibrated properly. Power points are place on the side and top for lighting and the bell.
The gate stanchion concrete should dry for at least four days. The gate is then lifted and put into position on the hinges. If the columns done correctly it will fit on the provide hinges. The top of the hinge is then capped by welding to prevent lifting of the gate. The tower bolt position is mark at the center of the gate. Two steel round hollow sections of one feet long are drive into the ground. A concrete surround done to prevent movement when locking the gate. For more information visit Gates And Garage